The bike frame on this bike has acheived the highest EFBe rating
on the MTB Hardtail Tri Test. This means the frame has passed a
comprehensive evaluation of the frames durability. The frame
withstood five fatigue tests with 100,000 cycles each. These
correspond to the loading cases present in standard bike operation:
DAKINE uses only the finest peel and stick adhesives to ensure easy installation and secure attachment. Please read and follow the instructions for best results.
Key Features of the Dakine X-Mat Snowboard Stomp:
Die cut vinyl
Size 3.7" x 3.7" [ 95mm x 95mm ]
Weight .6 oz. [ 17g ]
FOR OPTIMUM BONDING: 1. Board and stomp pad should be at room temperature 70 F [ 21 C ] 2. Clean surface with rubbing alcohol. Surface must remain clean, smooth and dry. Do not touch. 3. Use a blow dryer on high to heat up the prepared board surface as well as the adhesive on the traction device 4. Immediately after heating, place the traction device and press firmly. Stand on the traction without twisting, the more weight the better. 5. Allow the adhesive to cure at room temperature for 24 hours
I bought this stomp pad last season. It looks good and works but not too well. With snow all over your board its hard to get your foot locked in on it. Its better than having no stomp pad though, so for $8 I would recommend it
Iv'e had one of these for 5 years. Bought it in neon Pink so it would pop! If applied correctly this will not peel off your board, very impressed with how well it sticks. The grip is great as expected with spikes, no slipping. I have had maybe 3 or 4 little spikes break after all these years. It is small enough so it doesn't cover much graphic but still gives you great control off the lifts. I really like this pad and would buy it again
Hi everyone, I usually dont put stomp pads on my boards, but this one actually works great and really keeps your foot locked. It was like 5$ and I love it. If your looking for a cheaply priced stomp pad that actually works pick this one up. I put it on my k2 board and my boot size is a 9 and this thing would still hold me in
Best stomp pad available. The spikes really help so you can plant your boot firmly on it without slipping/missing the pad. Definitely invest the 10 dollars to get a stomp pad like this over and factory foam one.
I like this stomp pad because it is light. It grips your boot very well but after a long day some ice blocks it. It is cool because it takes the color of your board. This pad will help you get on and off of lifts.
This pad was extremely easy to put on my board, and reposition if necessary. I got the clear one so my board graphics would show through. It's actually hard to tell it's there when the board is clean. I have large feet, so the small size is a bit strange, but it's plenty of grab to make it useable
This is small and subtle and won't block most of the board's artwork. I certainly appreciate that. The little spikes can scratch you if you're carrying your board with a naked arm, but that's not really much to complain about. I chose this for how much it wasn't noticeable
I ordered this expecting it to perform like the identical Dakine stomp pad I purchased years ago. That thing stuck like cement and lasted forever. However, this one was horrible. It appeared that the adhesive stuck to the peel off paper instead of the pad. After following the directions, this thing didn't last 5 minutes.