|Reduced Diameter Compatible:||
|Manufacturer Warranty:||1 Year|
Description: Chinook Windsurfing Base 1 Bolt Tendon
The Chinook Windsurfing Base 1-Bolt Tendon is designed to fit low to the base which makes it easy to adjust. It has a unique, on center design that twists and tightens down onto the mast track. This mast base is designed for advanced riders and maximum strength.
Windsurfing Base 1
Bare with my reply if it is too simplistic as I'm not sure of your windsurfing experience - plenty of people try their best to piece together old gear so that's the tact that I'm taking.
With a sliding track you'll first and foremost need to recover your attachment pin. If you don't have that then we're in a bit of trouble. From there you will need to determine what type of extension that you have. With your track pin determine if it is male or female threaded. It will then either screw into the Chinook Rubber U-Joint seen here http://www.the-house.com/ch515zz-chinook-windsurfing-accessories.html or be coupled with the 30 or 40mm stud seen here http://www.the-house.com/cw002zz-chinook-windsurfing-accessories.html and http://www.the-house.com/cw003zz-chinook-windsurfing-accessories.html. Keep in mind to use locktite 262 (permanent) in all cases. Building up from the U-Joint you will need to consider your extensions. If Chinook or Fiberspar then build up with the Chinook base cup kit http://www.the-house.com/ch521zz-chinook-windsurfing-accessories.html.
Hope this helps. Dec 2, 2013